VCT Vision ELITE Series Especificaciones descargar pdf (Pagina 110)

GE H

EALTHCARE

IRECTION

DOC0500644, R

4 D

ISCOVERY

, L

IGHT

PEED AND

RIGHT

PEED

DICOM C

ONFORMANCE

TATEMENT

110 of 157

The configuration is performed by GEHC Field Service Engineers using software

environment variables.

7.7 SUPPORT OF EXTENDED CHARACTER SETS

PPS supports ISO_IR 100 character set.

7.8 N-CREATE & N-SET REQUEST MESSAGE

PPS Feature for LightSpeed supports all named attributes listed in Table F.7.2.1 in PS3.4

of DICOM standard. That is, attributes that are not explicitly referenced by name in the

table are not supported. (Example is last row in the table reads “All other attributes from

Radiation Dose Module and Billing and Material Code Module”. The attributes referenced

here are not supported).

For the MPPS associated with an acquisition, the following attributes are copied from the

Modality Worklist SCU into the MPPS request Message, if procedure performed

corresponds to the SPS information retrieved through the Modality Worklist.

LightSpeed supports the selection of single or multiple SPS for a scan. The following are

applicable.

• Single SPS selection results in single PPS message

• Multiple SPS selection results in single PPS message

• Multiple SPS selection is allowed only if they all correspond to same patient id

• A maximum of 15 SPS’s can be selected

• Referenced Study Sequence - a maximum of ten Item’s is supported. This attribute will

be present only if SPS information is available from Modality Worklist SCU.

• At the end of acquisition the user might choose to ‘Defer PPS’ and later choose to

‘Complete PPS’ or ‘Discontinue PPS’ from the user interface provided in the system.

In this case, the date and time when user chooses to ‘Complete PPS’ or ‘Discontinue

PPS’ is taken as the Performed Procedure Step End Date and Performed Procedure

Step End Time respectively (Not the actual end date and end time of acquisition)

• Mapping of SPS data to MPPS SOP instance is explained in section 7.10

• Mapping of specific SPS data to CT DICOM IMAGE HEADER , for PPS is explained

in section 7.11

For the MPPS associated with a post-processing the following restrictions apply on the

attributes listed below.

• Referenced Study Sequence – The sequence is not sent in the MPPS message

• Scheduled Step Attribute Sequence – a maximum of ONE item is supported. The

attribute will be send only if SPS information is available in the image instance.

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 156 157

Comentarios a estos manuales

Sin comentarios

VCT Vision ELITE Series Especificaciones Pagina 110

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad VCT Vision ELITE Series